Cleaning Or Replacing The Dust Brush; Cleaning The Water Tank En - hanseatic HVRB25SS Gebrauchsanleitung

Cleaning or replacing
the dust brush
• Use the comb (43) to clean the
dust brush (5) every now and
then.
Depending on use, it may be
necessary to replace one or both
of the dust brushes (5).
1. Hold onto the dust brush (5)
with one hand and use your
other hand to loosen the
screw (45) with a Phillips
screwdriver.
2. Remove the dust brush (5).
3. Put the new dust brush (5) on
the drive wheel and tighten it.
Care and maintenance Page EN-27
Cleaning the water tank
1. Open the filler cap (28) on the
water tank (29) as described in
Section "Filling the water tank"
on page EN-21 and pour fresh
water into the filling hole (30).
2. Pour the water which has been
mixed with a cleaning agent
(e.g. vinegar, household clean-
er) into the water tank (29).
3. Close the filler cap (28), give
the filled water tank (29) a
thorough shake, and then
(5)
leave it for a bit.
(45)
4. Open the filler cap (28) on the
water tank (29) and pour out
the water mixture inside the
water tank (29).
5. Repeat steps 2 and 4 with
clean water.
6. Leave the filler cap (28) open
so that the inside of the water
tank (29) can dry.