Automatic Display Of Status Codes; 0X0D - "Set Error Forwarding" (Automatic Display Of Status Codes - Interface Card / Interface Box / Inter- Face Unit Of Datalogger & Interface, Interface Card Easy) - Fronius IG 300 Bedienungsanleitung

Automatic Display of Status Codes

0x0D - "Set error The "0x0D - Set error forwarding" command is used to activate or deactivate the automatic
forwarding" (au- display of status codes for a system with up to 100 inverters via an RS 232 interface (in-
tomatic display of terface card / interface box / Datalogger & interface) and a system with 1 inverter via an
status codes - in- RS 232 interface (Interface card easy).
terface card / in- Status codes are only displayed if certain criteria are fulfilled (these are the criteria which
terface box / would trigger an SMS or e-mail dispatch in Fronius monitoring). The selected option con-
interface unit of tinues to be saved.
Datalogger & in-
terface, Interface When using interface card / interface box / Datalogger & interface:
Card easy) -
-
Example, command for activating automatic display of status codes for interface card /
interface box / interface unit of Datalogger & interface:
Start Length Device / Op-
Response:
Start Length Device / Op-
For Interface Card easy, please note:
-
-
Example, command for activating automatic display of status codes for Interface Card
easy:
Start Length Device / Op-
Response:
Start Length Device / Op-
enter error code "0x55" in the byte
in the Extra byte enter the day set on the Fronius Datalogger (e.g.: 23 June 2012 =
23dec -> 0x17)
tion
0x02 0x00
NOTE! To deactivate the automatic display of status codes in interface card / in-
terface box / interface unit of Datalogger & interface,
- enter error code "0x00" in the byte
- in the Extra byte enter the day set on the Fronius Datalogger (e.g.: 23 June
2012 = 23dec -> 0x17)
tion
0x01 0x00
enter error code "0x55" in the byte
Enter "0x02" in the Extra byte
tion
0x02 0x00
tion
0x01 0x00
NOTE! To deactivate the automatic display of status codes in an Interface Card
easy,
- enter error code "0x00" in the byte
- Enter "0x02" in the Extra byte
Number Com- Extra
mand
0x00 0x0D 0x17 0x55
Number Com- Error
mand code
0x0D 0x55
Number Com- Extra
mand
0x00 0x0D 0x02 0x55
Number Com- Error
mand code
0x0D 0x55
Error Check-
code sum
0x7B
Check-
sum
Error Check-
code sum
0x66
Check-
sum
185