Mode Of Installation; Opening The Unit; A - Models With Flap; B - Models With Console - Olimpia splendid Bi2 Air TR Hinweise Für Die Verwendung Und Pflege

e. The wall for installation is, possibly, an external perimeter wall in order to allow for drainage of
condensation to the exterior.
If it is not possible, please envisage a suitable drainage line for condensation.
f. In case of high installation, the air flow is not targeted directly against people.
g. The appliance must be installed in such a position as to allow for easy ordinary and extraordinary
maintenance, as well as for easy access to the air breather valves which can be reached from
the upper grille of the connections side.

2.2 - MODE OF INSTALLATION

The following descriptions on the various phases of assembly and the corresponding drawings refer to a
version of the machine with connections to the left.
The descriptions for the assembly operations of the machines with connections to the right are the same.
Only the figures must be considered as shown specularly.

2.3 - OPENING THE UNIT

2.3.a - Models with flap (Fig.3)
a. Delicately rotate the air outlet flaps 90°.
b. Undo the 4 fixing screws highlighted in the figure.
c. Make the front part tilt slightly, then raise it.
d. Disconnect the command display-board connector.

2.3.b - Models with console

a. Undo the two fixing screws (11a) and dismount the upper grille (11) (fig.21).
b. Open the left door (12) (fig.21a).
c. Undo the screw (12a) and slightly move the left flank leftwards (13) and then raise it (fig.21a).
d. Raise the lid (14a) which covers the screw (14b) positioned on the right side of the appliance (fig.21b).
e. Undo the screw (14b) and slightly move the right flank leftwards (14) and then raise it (fig.21b).

2.4 - WALL OR VERTICAL FLOOR INSTALLATION

In case of floor mounting with the bases, for their mounting, please refer to the single instruction sheets
supplied and to the corresponding manual.
a. Use the template in the packaging (to be cut along the indicated lines) and mark on the wall the position
of the two fixing brackets (fig. 4).
b. Drill using an appropriate bit and insert the dowels (T), 2 for each bracket (fig. 4).
c. Secure the two brackets (S) (fig. 5). Do not tighten the screws excessively, so as to be able to adjust the
brackets using a bubble level (fig. 6).
d. Definitively lock the two brackets (S) by tightening the four screws completely.
e. Ensure their stability by manually moving the brackets rightwards and leftwards, up and down.
f. Mount the unit checking correct hooking on the brackets and its stability (fig. 7).
g. To configure the electronic part, please refer to paragraph "3.4 Configuration".
EN - 9
Bi2 Air TR