Placing The Dpx-1300 In Standby Mode - Yamaha DPX-1300 Bedienungsanleitung

Placing the DPX-1300 in standby mode

button STANDBY/ON button
AUTO
STANDBY/ON
V. POS ZOOM FOCUS
IRIS SETTING PATT
ESCAPE
MENU
ESCAPE
PATTERN
ASPECT
LAMP COVER
INPUT
ASPECT
Remote Control Main unit
AC inlet
OUT IN
DVI HDMI RS-232C TRIGGER OUT
REMOTE
INPUT A
INPUT B
RGB/YP P /YC C D4 VIDEO G/Y B/P /C R/P /C HD/SYNC VD S-VIDEO
B R B R B B R R
1. Press the STANDBY/ON button.
A confirmation message appears on the
screen.
MENU
SETTING
INPUT
TEMP FAN
2. If you wish to place the DPX-1300
in standby mode, press the
STANDBY/ON button again.
The lamp changes to a half lit state, and the
fan activates for 2 minutes to cool the lamp.
During this time, the STANDBY/ON
indicator blinks red, and pressing
STANDBY/ON does not turn main unit
power on again. When the unit finishes
cooling, the fan stops, and the STANDBY/
ON indicator turns red.
Memo
• The lamp may blink when half lit. This is not a defect.
Warning
• Do not remove the power cable while the STANDBY/ON indicator is blinking green
or when the fan is activated. This could damage the lamp or reduce lamp life.
• This unit is not disconnected from the AC power source as long as it is connected
to the AC outlet, even if this unit itself is turned off by STANDBY/ON.This state is
called the standby mode. In this state, this unit is designed to consume a very small
VIDEO
quantity of power.
• If you do not plan to use the main unit for a long period of time, attach the lens cap
and remove the plug from the AC outlet.
• Condensation may appear on the unit if the temperature of the surrounding
environment changes quickly. Condensation may also cause the projected image to
be cloudy. Place the unit in standby mode until the condensation disappears.
Switching the unit on when condensation is present may damage the unit.
Turning the projector power on
Press again to enter standby.
8
19