Kübler Sendix S3674 Betriebsanleitung Seite 21

4.1.2.4 Application Side
Flange type 1 with stator coupling, ø 38
Mounting suggestion
Flange type 4 with stator coupling, ø 60
Mounting suggestion
BA Sendix® S3674 / S3684 - R60071.0009 - 03
Flange type 5 with stator coupling, ø 55
Mounting suggestion
173215243
4.1.3 Assembly Instructions for Motor Feedback
Encoders in Tapered Shaft Version
a) Block the drive shaft for the assembly.
b) Carefully slide the encoder on the shaft. Take care not to
bend the torque stop (stator coupling) during this opera-
tion.
c) Tighten the fastening screw of the tapered shaft with a
1 Nm [0.74 ft-lb] torque.
d) Comply with the maximum permissible shaft offset.
e) Screw the stator coupling or the torque stop without pre-
load on the drive flange. Tighten the screws with a 1 Nm
[0.74 ft-lb] torque.
f) Secure the screws against loosening, see Screw Reten-
173217675
tion.
173264651
EN - 21