AsViva C16 Benutzerhandbuch Seite 42

ASSEMBLY INSTRUCTION
1. Attach the left pedal (9) to the left pedal tube (11). Secure using two carriage bolts (44), two
flat washers (65) and two nylon locknuts (42). Repeat for the Right pedal (10).
2. Attach the stationary handlebar (18) to the back of the front support (13). Secure using two
allen bolts (30) and two curve washers (31).
3. Connect middle monitor wire (60) to upper monitor wire (83) of the monitor (19).
4. Remove the grommet (61) from the front support. Slide the handpulse wires (63) through the
grommet (61). Slide the wires through the hole in the front support and up towards the
monitor bracket. Push the grommet into the front support. Connect the hand pulse wires
(63) to back of the monitor (19). --- Delete these sentences.
5. Attach the monitor (19) on to the bracket of the front support (13). Secure the monitor (19)
using four screws (62) which are pre-assembled on the back of monitor.
Note: Make sure all the wires are put into the groove at the back of the monitor before you slide the
monitor on to the front support to avoid pinching the wires.
STEP 4
42 / 52