Operating Instructions; Remote Control; Starting The Mover - Truma Mover smart A Gebrauchsanweisung

Operating instructions

Remote control

Mover
smart A
1
2
10
9 3
8 4
5
7
6
Mover
smart
Figure 2
1 Move the caravan forward
2
Engage the Mover (only Mover smart A)
3 Turn the caravan in a clockwise direction (via the right
axle)
4 Switch off (red) / emergency stop switch
5 Turn the caravan in an anti-clockwise direction (via the
right axle)
6
Move the caravan backward
7 Turn the caravan in a clockwise direction (via the left
axle)
8 Switch on (green)
9 Turn the caravan in an anti-clockwise direction (via the
left axle)
10
Disengage the Mover (only Mover smart A)

Starting the Mover

Follow the "Safety instructions" before using the
Mover.
– Establish the power supply for the Mover via the battery
cut-off switch.
– With the caravan uncoupled from the towing vehicle (park-
ing brake engaged and/or secured against rolling away)
engage the Mover.
Mover
smart M
1
9 3
8 4
5
7
6
Mover
smart
Engaging the Mover smart A
– Switch on the remote control. (see "Switching on the re-
mote control")
– Press the button (Figure 3 - 2) on the remote control for
about 5 seconds and then release it. The drive roller engag-
es. The display (Figure 3 -1) flashes during this process.
When the remote control display stops flashing, the pro-
cess is complete and the remote control can send new
commands.
Figure 3
Engaging the Mover smart M
– Attach the engagement lever to the toggle crank
(Figure 4 - 1).
Figure 4
– Turn the engagement lever in the direction of the arrow (to-
wards the vehicle wheel) (Figure 4 - 2) until the position in-
dicator is at "√" (Figure 5 - 1) in the housing. In the end po-
sition, the drive unit engages securely and the drive roller is
pressed approx 20 mm into the tyre. This must be checked
on both sides before manoeuvring.
Figure 5
– Removing the engagement lever
Both drive rollers must be pressed firmly on to the tyres.
1
2
2
1
1
EN 13