Error Codes; Error Indications - Fujitsu AIRSTAGE ASYE07GACH Installationsanleitung

10. ERROR CODES

If you use a wired type remote controller, error codes will appear on the remote controller
display. If you use a wireless remote controller, the lamp on the photodetector unit will output
error codes by way of blinking patterns. See the lamp blinking patterns and error codes in the
table below.

Error indications

OPERATION TIMER lamp
lamp (green)
(1)
(1)
(1)
(2)
(2)
(3)
(3)
(3)
(4)
(4)
(5)
(5)
(5)
(9)
(13)
Display mode
Wired Remote Controller Display
UTY-RNKY / UTY-RNKG / UTY-RNKYT (3-wire type)
URY-RNRY / UTY-RNRG (2-wire type)
Touch the [Status].
For more information, refer to the installation manual of the remote controller.
En-15
9377773098-01_IM.indb 15 9377773098-01_IM.indb 15
Downloaded from www.Manualslib.com
Wired Remote
Controller Error
FILTER lamp
CODE
(orange) (red)
Remote controller
(2)
communication error
Network communication
(4)
error
Peripheral device
(6)
communication error
(6) Address setting error
Connection unit number
(9) error in wired remote
controller system
Indoor unit power supply
(1)
abnormal
Indoor unit main PCB
(2)
error
Indoor unit
communication circuit
(10)
(wired remote controller)
error
(1) Room temp. sensor error
Indoor unit Heat Ex.
(2)
sensor error
Indoor unit fan motor1
(1)
error
Coil (Expansion value)
(2)
error
(3) Water Drain Abnormal
(15) Outdoor unit error
(1) RB unit error
: 0.5s ON / 0.5s OFF
: 0.1s ON / 0.1s OFF
( ) : Number of fl ashing
Error code
Touch the [Next Page] (or [previous page])
Error icon
to switch to other indoor unit information.
Touch the [Error Information].
2-digit numbers are corresponding to
the error code in the preceding table.
manuals search engine
Error contents
7/12/2012 3:05:27 PM 7/12/2012 3:05:27 PM