Error Codes - Fujitsu AIRSTAGE ARXC36GATH Installationsanleitung

10.

ERROR CODES

If you use a wired type remote controller, error codes will appear on the remote controller ] 1
display. If you use a wireless remote controller, the lamp on the photodetector unit will
output error codes by way of blinking patterns. See the lamp blinking patterns and error
codes in the table below.
Error indications
OPERATION TIMER lamp
lamp (green)
(1)
(1)
(1)
(2)
(2)
(3)
(3)
(3)
(4)
(4)
(5)
(5)
(5)
(9)
(13)
Display mode
9373870111-01_IM.indb Sec1:14 9373870111-01_IM.indb Sec1:14
Downloaded from www.Manualslib.com
Wired Remote
Controller
FILTER lamp
Error code
(orange) (red)
Remote controller
(2)
communication error
Network communication
(4)
error
Peripheral device
(6)
communication error
(6) Address setting error
Connection unit number
(9) error in wired remote
controller system
Indoor unit power supply
(1)
abnormal
Indoor unit main PCB
(2)
error
Indoor unit
communication circuit
(10)
(wired remote controller)
error
(1) Room temp. sensor error
Indoor unit Heat Ex.
(2)
sensor error
Indoor unit fan motor1
(1)
error
Coil (Expansion value)
(2)
error
(3) Water Drain Abnormal
(15) Outdoor unit error
(1) RB unit error
: 0.5s ON / 0.5s OFF
: 0.1s ON / 0.1s OFF
( ) : Number of fl ashing
manuals search engine
Wired Remote Controller Display
UTY-RNKY / UTY-RNKG / UTY-RNKYT (3-wire type)
Error contents
URY-RNRY / UTY-RNRG (2-wire type)
Touch the [Status].
For more information, refer to the installation manual of the remote controller.
For details on marking the ERROR CODES, please refer to the Manual of "IR Receiver
Unit" or "Wired Remote Controller".
Error code
Touch the [Next Page] (or [previous page])
Error icon to switch to other indoor unit information.
Touch the [Error Information].
2-digit numbers are corresponding to
the error code in the preceding table.
En-14
2012-7-12 14:19:06 2012-7-12 14:19:06