The Dishwashing Results Are Not Satisfactory - hanseatic HGTI6082C147735TS Gebrauchsanleitung

The dishwashing results are not satisfactory

Problem Possible cause
There are resi- The rinse aid is incorrectly dosed.
dues or streaks
on the dishes.
There is no dishwasher salt.
The dishwasher salt is clumpy.
The dishes are There are food scraps which are
not completely encrusted onto the dishes.
clean.
The dishes have not been
stacked optimally.
You have selected the incorrect
dishwashing programme.
The dishwasher detergent is in-
correctly dosed.
The water pressure is too low.
The spraying arm can not rotate
unhindered.
The nozzles on the spraying arm
are blocked/calcified.
Troubleshooting table
Solution
Adjust the dispensed dose (see
"Adding rinse aid" on page EN-14).
Add dishwasher salt (see "Adding
dishwasher salt" on page EN-16).
Stir the dishwasher salt using the
end of a spoon or similar.
Soak dirty dishes prior to washing
the dishes.
Stack the dishes in such a way
that all parts can be reached by
the water jets (see "Loading the
dishwasher" on page EN-17).
Select the correct dishwashing
programme (see "Selecting pro-
gramme and starting the pro-
gramme run" on page EN-23).
Use the correct dosage of dish-
washer detergent (see "Pro-
gramme table" on page EN-21).
Turn the water tap on completely.
Ensure that no dishes are imped-
ing the motion of the spraying
arm.
Clean the nozzles (see "Check-
ing and cleaning the spraying
arm and spray nozzles" on page
EN-28).
Page EN-39