Operation; Preparation; Before Getting Started; Protecting The Environment - hanseatic HGTI6082C147735TS Gebrauchsanleitung

Page EN-22

Operation

Operation
(1) (2) (3) (4)
(10) (11) (12) (13)
(28) (27) (26)

Preparation

Before getting started:

• Read chapter "Safety" from page EN-4, in
particular the safety instructions.
• Set up and connect the appliance as
described in chapter "Set-up, connection
and initial start-up" from page EN-29.
• Refill dishwasher detergents, rinse aids
and dishwasher salts or multi-tabs.
1. Open the tap completely.
2. Close the dishwasher door.
3. Touch the sensor (1) to switch the dish-
washer on.
You will hear a signal tone and all LEDs will
illuminate briefly.
After a short time, the details of the ECO
programme indicator (12) will appear on
the display (5).
(5)
(14) (15)

Protecting the environment

– The ECO programme is the most efficient
programme for cleaning normally soiled
dishes in terms of combined energy and
water consumption.
– If you keep to the maximum specified ca-
pacity when loading your appliance and
you arrange the dishes correctly, energy
and water can be saved (information from
page EN-17).
– Manual pre-rinsing of the dishes leads to
higher water and energy consumption and
is not recommended.
– Cleaning dishes in your appliance gen-
erally uses less energy and water than
washing by hand, provided you follow the
instructions in the user manual.
(6) (7) (8)
(16) (17) (18) (19)
(25) (24) (23) (22)
(9)
(20)
(21)