Preliminary Checks; During Use - Corghi A 2030 Betriebsanleitung

• Employers are required to make sure that operators do not work on the wheels unless they
have received suitable training regarding the correct maintenance procedures for the type
of wheel being serviced and the operative safety procedures.
• Information to be used for the training program includes, as a minimum, the information
contained in this manual.
2. Employers are required to make sure that every employee demonstrates and maintains the
ability to work on the wheels safely, including the performance of the following activities:
• Demounting of tyres (including deflation).
• Inspection and identification of the rim wheel components.
• Tyre mounting.
• Use of any restraint device, cage, barrier, or other systems.
• Handling of wheels with rims.
• Tyre inflation.
• Move away from the tyre changer while inflating the tyre and do not lean over to inspect
the wheel during inflation.
• Wheel installation and removal.
3. Employers must evaluate the ability of their employees to carry out these tasks and work
on the wheels in absolute safety and must provide additional training as required to make
sure that all employees maintain their skills.

1.6. PRELIMINARY CHECKS

Before starting to work, carefully check that all machine components, particularly rubber or
plastic parts, are in place, in good condition and operate correctly. If the inspection reveals any
damage or excessive wear, no matter how slight, immediately replace or repair the component.
Walk around the machine to ensure that all components are in good condition and operational,
and that there are no foreign objects or debris (rags, tools, etc....) in or near the machine
which could affect its operation.
These checks must be carried out:
• Before starting the machine.
• At regular time intervals.
• After any modification or repair.
The machine may only be started after this pre-use check is successfully completed. Do
not use the machine if it is placed out of service for tune up, maintenance, lubrication, etc.

1.7. DURING USE

If strange or unusual noises are heard or any unusual vibration is detected, if a component
or system is not operating correctly or if you observe anything unusual, immediately stop
using the machine.
• Identify the cause and implement all the necessary corrective measures.
• Contact your supervisor if necessary.
Make sure that all other people are standing at least 6 metres (20 feet) from the machine.
To switch off the machine in case of emergency:
• disconnect the power supply plug;
• interrupt the compressed air supply by disconnecting the supply pipe.
A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224 Operator's manual
92