Periodic Checks; Scrapping - Corghi A 2030 Betriebsanleitung

Periodically check the lubricant level through the specific windows and top up as shown
in fig.42c. Top up only with non-detergent SAE20 oil equal to 50cc.
The filter regulator "FR" has an automatic condensation drain system, therefore in conditions
of normal use special maintenance is not required. The condensate may however be
drained manually at any time (fig.42d). Normally the cups do not need to be removed,
but check if this is necessary for maintenance operations after a long period of use. If a
manual operation is not sufficient, use the specific key provided (fig.42e).
Clean with a dry cloth. Avoid contact with solvents.
NOTE: for oil warnings, refer to the specific chapter in the machine user manual.
To keep the machine in optimal conditions of safety and operation, the employer must
have the following periodic checks performed by the authorized service network.

Periodic checks

a. periodic check of inflation pressure gauge every 2 years
b. periodic check of the inflation pressure relief valve every 2 years
c. periodic check of the regulator filter of the pneumatic supply at the machine inlet
every 2 years
d. periodic check of the functionality of all the machine controls every 2 years
e. periodic check of the maximum pressure relief valve mounted on the tanks every 2
years
f. check of some parts of the machine such as: safety and protection devices, parts subject
to wear, parts subject to pressurized fluids (tanks, connections, pipes, etc.), electrical
connections etc.

11. SCRAPPING

If the equipment is to be scrapped, sort all electrical, electronic, iron and plastic components.
Dispose of the components separately in compliance with local regulations.
A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224 Operator's manual
CAUTION
EN
125