Tyre Inflation; Special Procedure (Ti Version) - Corghi A 2030 Betriebsanleitung

NO
YES
30
8.8.b. TYRE INFLATION
-Make sure the wheel is NOT clamped on the
turntable by the centring jaws (Fig. 30).
- Move the horizontal arm to the wheel centre (all
slipped off towards the operator)
31
- Lower the vertical arm until it touches the rim
(fig.31), then clamp the arm in this position (fig. 31a).
- Remove the valve core if it has not already been
removed (Fig. 32).
- Connect the Doyfe connector of the inflating hose
to the valve stem (Fig. 33).
- Inflate the tyre with the appropriate gun or by
pressing the pedal in an intermediate position (Fig.
31a
39). Frequently check the pressure on the pressure
gauge to make sure that the pressure NEVER exceeds
the maximum pressure indicated
by the manufacturer on the tyre.
- Disconnect inflation hose from
valve rod.
- Press the pedal to move
the column into the "non-working
33
32
position".
- Remove the wheel from the tyre
EN
changer.
8.8.c. SPECIAL PROCEDURE (TI VERSION)
A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224 Operator's manual 117