Appliance-Specific Safety Instructions For Electric Staple Guns; Safety Guidelines For Battery Chargers - Parkside PAT 20-Li A1 Originalbetriebsanleitung

Appliance-specific safety instructions
for electric staple guns
■
Always assume that the power tool
contains staples. Careless handling of the
tacker can lead to unexpected ejection of
staples which could cause injuries.
■ Never aim the power tool at yourself or
other people in the vicinity. Unintended
triggering will cause a staple to be shot out,
which can lead to injuries.
■ Do not activate the power tool until it is
pressed firmly against the workpiece. If the
power tool is not in contact with the workpiece
the staple can rebound off the fastening point.
■ Disconnect the power tool from the mains
or battery if a staple becomes jammed
in the power tool. If the tacker is connected,
it could be unintentionally activated while
removing a jammed staple.
■
Be careful when removing a jammed
staple. The system may be under tension and
the staple could be forcefully ejected while you
attempt to unblock the jam.
■ Never use this tacker for fastening elec-
trical cables. It is not suitable for the installa-
tion of electrical lines, can damage the insula-
tion of electrical cables and thus cause
electrical shocks and increase the risk of fire.
│ GB │ IE │ NI
■ 6
Safety guidelines for battery
chargers
This appliance may be used by
■
children aged 8 years and above
and by persons with limited phys-
ical, sensory or mental capabilities
or lack of experience and knowl-
edge, provided that they are under
supervision or have been told how
to use the appliance safely and are
aware of the potential risks. Do not
allow children to use the appliance
as a toy. Cleaning and user mainte-
nance tasks may not be carried out
by children unless they are super-
vised.
The charger is suitable for
indoor use only.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP 20 A3.
♦ A current list of battery compatibility can be
found at www.lidl.de/Akku.
WARNING!
■ If the connecting cable needs to be replaced,
this must be carried out by the manufacturer
or an authorised representative in order to
avoid safety hazards.
PAT 20-Li A1