Power Control; Energy Save; No Signal Off; No Operation Off - Pioneer PDP-5080XD Bedienungsanleitung

08 Setting up

Power Control

Power Control provides convenient functions for power saving.

Energy Save

You may use one of the three Energy Save modes to save power
consumption.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "Energy Save" (/ then ENTER).
4 Select "Mode 1", "Mode 2", or "Picture Off" (/ then
ENTER).
Energy Save
Selections Off
Mode 1
Mode 2
Picture Off
5 Press HOME MENU to exit the menu.
Note
• When you change the Energy Save mode, you may notice a
change in the panel sound. This is normal.
• The Energy Save function can maintain efficiency of the screen
for a long period of time. Setting the Energy Save function to
"Mode 1" is recommended in order to maintain the efficiency of
the screen for a long period of time.
36
En
Downloaded from www.Manualslib.com
Does not decrease the picture
brightness
Slightly lowers power consumption
while slightly suppressing the
brightness drop level
Decreases the picture brightness
and lowers power consumption
Deactivates the screen to save
power. To restore the screen
display, press any button other
than i +/i – and e.
This setting is not memorized by
the system.
manuals search engine
No Signal off (AV source only)
The system will be automatically placed into the standby mode if no
signal is received for 15 minutes.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "No Signal off" (/ then ENTER).
4 Select "Enable" (/ then ENTER).

No Signal off

Selections Disable
(default)
Enable
5 Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby mode,
a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the plasma television after a TV
programme finishes.
No Operation off (AV source only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "No Operation off" (/ then ENTER).
4 Select "Enable" (/ then ENTER).

No Operation off

Selections Disable
(default)
Enable
5 Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby mode,
a message appears every minute.
Does not place the system into the
standby mode
Places the system into the standby
mode if no signal is received for 15
minutes
Does not place the system into the
standby mode
Places the system into the standby
mode if no operation is performed
for three hours