Power Control; Listening To Audio From The Sub Screen Using Headphones; Energy Save - Pioneer PDP-507XA Bedienungsanleitung

Basic Adjustment Settings
Listening to audio from the sub screen
using headphones
With headphones connected, you can listen to audio coming
from the sub screen when in the 2-screen or picture-in-picture
mode; audio coming from the main screen is output from the
speakers. To use this function, follow the procedure below.
1
Press HOME MENU.
2
then ENTER).
Select "Sound" ( /
3
Select "Headphone Output" ( / ).
4
Select the desired parameter ( / ).
Front Surround
Headphone Output
Sub Volume
Item Description
Main Audio coming from the main screen is output
(factory default)
from the PHONES output terminal.
Sub When in the 2-screen or picture-in-picture mode,
audio coming from the sub screen is output
from the PHONES output terminal.
5
Select "Sub Volume" ( / ).
6
Select the desired volume level ( / ).
Front Surround
Headphone Output
Sub Volume
7
Press HOME MENU to exit the menu.
NOTE
• To adjust the volume for headphones after selecting "Sub",
always use the menu item (shown in the procedure) no
matter whether the screen is in the single, 2-screen, or
picture-in-picture mode. When the screen is in the single
mode with "Sub" selected, audio coming from the screen is
output from speakers even with headphones connected.
• Audio from a connected subwoofer is muted when you have
selected "Sub" for "Headphone Output" and connected
headphones.
Off
Main
15
Off
Sub
15

Power Control

Power Control provides convenient functions for power saving.

Energy Save

You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Energy Save" ( /
4
Select "Save 1","Save 2", or "Picture Off" ( /
ENTER).
Item Description
Standard Does not decrease the picture brightness.
Save1
Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Save2
Decreases the picture brightness and lowers
power consumption.
Picture Off
Deactivates the screen to save power. To restore
the screen display, press any button other than
i +/i – and e.
This setting is not memorized by the system.
5
Press HOME MENU to exit the menu.
NOTE
• You can also select this function using the Home menu
when the input source is a PC.
• When you change the Energy Save mode, you may notice a
change in the panel sound. This is normal.
No Signal off (AV mode only)
The system will be automatically placed into the standby mode
if no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Signal off" ( /
4
then ENTER).
Select "Enable" ( /
Item Description
Disable Does not place the system into the standby
(factory default) mode.
Enable
Places the system into the standby mode if no
signal is received for 15 minutes.
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Plasma Television after a TV
programme finishes.
then ENTER).
then ENTER).
then
then ENTER).
then ENTER).
08
35
En