Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting up
Note
• You cannot adjust the front surround effect for listening with
headphones.
• If you change the front surround effect with headphones
connected, the new setting will become effective as soon as you
disconnect the headphones.
•
(WOW) designates a status where the FOCUS is on and
TruBass + SRS has been selected for Front Surround.
•
is a trademark of SRS Labs, Inc.
• WOW technology is incorporated under license from SRS Labs,
Inc.
• The effect of this function differs depending on signals.
Power Control
Power Control provides convenient functions for power saving.
Energy Save
You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select "Power Control" (/ then ENTER).
3
Select "Energy Save" (/ then ENTER).
4
Select "Save1", "Save 2", or "Picture Off" (/ then ENTER).
Energy Save
Selections
Standard
Does not decrease the picture brightness.
Save1
Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Save2
Decreases the picture brightness and lowers
power consumption.
Picture Off
Deactivates the screen to save power. To
restore the screen display, press any button
other than i +/i – and e.
This setting is not memorized by the system.
5
Press HOME MENU to exit the menu.
Note
• When you change the Energy Save mode, you may notice a change
in the panel sound. This is normal.
No Signal off
The system will be automatically placed into the standby mode if no
signal is received for 15 minutes.
1
Press HOME MENU.
2
Select "Power Control" (/ then ENTER).
3
Select "No Signal off" (/ then ENTER).
4
Select "Enable" (/ then ENTER).
No Signal Off
Selections
Disable (default) Does not place the system into the standby
mode.
Enable
Places the system into the standby mode if no
signal is received for 15 minutes.
5
Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby mode, a
message appears every minute.
• The system may not be placed into the standby mode when noise
signals are present at the plasma television after a TV programme
finishes.
No Operation off
The system will be automatically placed into the standby mode when
no operation is performed for three hours.
1
Press HOME MENU.
2
Select "Power Control" (/ then ENTER).
3
Select "No Operation off" (/ then ENTER).
4
Select "Enable" (/ then ENTER).
No Operation Off
Selections
Disable (default) Does not place the system into the standby
mode.
Enable
Places the system into the standby mode if no
operation is performed for three hours.
5
Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby mode, a
message appears every minute.
08
33
En
Werbung
Kapitel
Inhaltsverzeichnis
