Pioneer PDP-5080XD Bedienungsanleitung Seite 37

Setting up
Power Management (PC source only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "Power Management" (/ then ENTER).
4 Select "Mode 1" or "Mode 2" (/ then ENTER).
Item Description
Off (default) No power management
Mode 1 • Places the system into the standby mode when
no signal is received from the personal computer
for eight minutes.
• Even when you start using the computer and a
signal is received again, the system stays off.
• The system is switched on again by pressing
STANDBY/ON on the plasma television or a on
the remote control unit.
Mode 2 • Places the system into the standby mode when
no signal is received from the personal computer
for eight seconds.
• When you start using the computer and a signal
is input again, the system is switched on.
• The system is switched on again by pressing
STANDBY/ON on the plasma television or a on
the remote control unit.
5 Press HOME MENU to exit the menu.
Note
• This function is not selectable when the PC is connected to the
HDMI terminal.
Downloaded from www.Manualslib.com manuals search engine
08
37
En