Commissioning - Continental ContiConnect Telematic Kit Installationsanleitung

Commissioning

If the ContiPressureCheck system is put into operation for the first time,
the system must be initialized in accordance with the following steps.
EN
1. Ensure that the CCU and the central telematics unit are supplied
2. Connect the hand-held tool to the diagnostic port on the display
3. Follow the instructions for initializing and configuring the
In case the central telematics unit has been connected to an existing
ContiPressureCheck system that has already been used, a complete
initialization will not be necessary. In this case, check the CAN setting
used previously and change it to CPC + J 1939 if needed.
NOTE
►
If a ContiPressureCheck system without a display
(variant B) is used, initialization of the system is only
possible once the central telematics unit has been
installed. The hand-held tool must be connected to
the system by means of a diagnostic plug on the
wiring harness L.
with power.
(variant a) or wiring harness L (variant B) and switch it on.
ContiPressureCheck system according to the manual for the hand-held
tool. This can be downloaded from
www.contipressurecheck.com/downloads.
NOTE
►
It is mandatory that the ContiPressureCheck system be
configured according to CAN bus format CPC + J1939.
22