30
5.4
INSTALLATION DIMENSIONS
Installation dimension
A: Installation length
B: Unit width
C: Height above pipe centre
D: Height below pipe centre
F: Input side to waste water connector middle
G: Waste water nominal diameter
All dimensions in [mm] (see fig. 4)
5.5
MOUNTING THE HEATING CIRCUIT REFILL UNIT
The heating circuit refill unit must be installed in the pipe so that the outlet hopper points vertically down-
wards, so that the exiting water can run away without obstruction. An installation location with easy access
simplifies maintenance and inspection.
Select the tightening torque (about 4 Nm) so that the seal is effective and the heat-
ing circuit refill unit is not damaged or strained!
The installation location must be frost-free and well ventilated.
Fig. 4: Installation dimensions
Y = sewer connection necessary
CLEAR FILL
222
105
73
153
88
40