Dangers Due To Non-Observation; Electrial Devices/Installations - Conel CLEAR FILL Montage- Und Betriebsanleitung

Additional dangers exist in the event of incorrect use and if the danger symbols and safety instructions are
ignored. The manufacturer/supplier shall not be responsible for any resulting damage. All risks are borne
solely by the user.
Intended use includes observance of the operating instructions.
The manufacturer/supplier must be consulted before using the heating circuit refill unit outside the limits
of use described in these operating instructions. The water heating circuit refill unit system must only be
used as intended in a technically fault-free state, while maintaining safety and hazard awareness, and in
compliance with the operating instructions.
Ensure that malfunctions are rectified immediately!
4.2

DANGERS DUE TO NON-OBSERVATION

In particular, non-observation of the general danger symbols is associated with the following typical haz-
ards:
/ Failure of important heating circuit refill unit functions,
/ Endangering of persons due to electrical and mechanical effects,
/ Endangering of persons and the environment due to leaks.
Any working methods that might endanger safety must be avoided.
Non-observation of these operating instructions and the safety instructions herein may endanger per-
sons, as well as the environment and the heating circuit refill unit itself.
4.3

ELECTRIAL DEVICES/INSTALLATIONS

No electrical cables and equipment may be located below or in the immediate vi-
cinity of the heating circuit refill unit!
Electrical devices/installations that are not splash-proof and are located in the vicinity of the heating cir-
cuit refill unit, may be damaged by water that escapes during installation or in the event of incorrect use of
the heating circuit refill unit.
If the electrical devices/installations are connected to the power supply, it is also possible that a short-cir-
cuit could occur.
Should this occur there is a risk of electric shocks to people.
Therefore electrical devices/installations in the vicinity must be splash-proof and/or comply with the legal
regulations for wet areas (IP44).
27