Error Code - Quicke Q-Companion BT Originalbetriebsanleitung

Error code

5. ERROR CODE
Error FMI Description
code
520461 2 Lift Angle Sensor - Data Erratic. Inconsistent readings from
3 Lift Angle Sensor - Voltage
High.
4 Lift Angle Sensor - Voltage Low. Sensor broken, short-circuited to
14 Lift Angle Sensor - Special
Instruction.
520464 2 Tilt Angle Sensor - Data Erratic. Inconsistent readings from
3 Tilt Angle Sensor - Voltage High. Sensor broken or short-circuited
4 Tilt Angle Sensor - Voltage Low. Sensor broken, short-circuited to
14 Tilt Angle Sensor - Special
Instruction.
520465 3 Pressure Sensor A - Voltage
High.
4 Pressure Sensor A - Voltage Low. Sensor broken, short-circuited to
14 Pressure Sensor A - Special
Instruction.
520466 3 Pressure Sensor B - Voltage
High.
4 Pressure Sensor B - Voltage Low. Sensor broken, short-circuited to
14 Pressure Sensor B - Special
Instruction.
520448 5 Loader Lights - Current Low.
6 Loader Lights - Current High.
520453 4 Output stage - Voltage below
normal.
520458 3, 4, 7, Output stage – Main activation
12, 14 failure.
520467 2 Communication – Intermittent
CAN bus off.
31 Communication – Permanent
CAN bus off.
* Electronic Control Unit - Attached at the front of the loader
Reason
sensor.
Sensor broken or short-circuited
to battery.
ground or not connected.
Internal error in ECU*.
sensor.
to battery.
ground or not connected.
Internal error in ECU*.
Sensor broken or short-circuited
to battery.
ground or not connected.
Internal error in ECU*.
Sensor broken or short-circuited
to battery.
ground or not connected.
Internal error in ECU*.
Loader lights broken or not
connected.
Short-circuit to ground or battery.
Output is turned off.
Internal inhibit detected.
Failure to activate the output
stage.
Loader ECU tries to recover
from CAN bus off.
Loader ECU failed to recover
from CAN bus off. ECU made
ten attempts to recover from
CAN bus off but failed.
40
Action
Check sensor and its harness.
Check sensor and its harness.
Check sensor and its harness.
Contact your dealer.
Check sensor and its harness.
Check sensor and its harness.
Check sensor and its harness.
Contact your dealer.
Check sensor and its harness.
Check sensor and its harness.
Contact your dealer.
Check sensor and its harness.
Check sensor and its harness.
Contact your dealer.
Check loader lights and its
harness.
Check loader lights and its
harness. Turn off loader lights to
remove error code and re-enable
the output.
Contact your dealer.
Contact your dealer.
No action.
Check connectors and harnesses
to the Display and to the Loader.
Reboot the system to remove
the error code. If error persists,
contact your dealer.