Quicke Q-Companion BT Originalbetriebsanleitung Seite 19

2.2.7. Select existing load weighing
calibration
To change to another load weighing calibration for the active implement, enter Implement view, select the active implement and
then Weighing calibrations. The list of available calibration is shown.
Weighing calibrations
cal.1
cal.2
gravel
New calibration
1. Select which calibration you want to activate.
2.2.8. Rename load weighing calibration
The name of a load weighing calibration can be changed to make it easier to distinguish between the different calibrations and
their purposes.
Weighing calibrations
cal.1
cal.2
gravel
New calibration
1. Select which calibration you
want to rename.
Fig.15 Select existing load weighing calibration
gravel
Select
Edit name
Calibrate
Delete
2. Select Edit name and press
confirm.
Fig.16 Rename load weighing calibration
gravel
Select
Edit name
Calibrate
Delete
2. Select Select and press confirm.
3. Change name by pressing up or
down and right or left. Confirm name
by pressing right when on the last
character.
17
gravel
Edit name
grave
l _
Setup