Quicke Q-Companion BT Originalbetriebsanleitung Seite 16

Setup
2.2.4. Delete implement
To delete an implement, enter Implement view and select the implement you want to delete.
Note. All the load weighing calibrations for the implement will be deleted. All the activities, as well as all the activities that
were recorded while using the implement will also be deleted, unless they are exported to the mobile app.
Implements
fork / cal.a
balegrip / cal.b
bucket / gravel
New implement
1. Select which implement to delete and press
confirm.
2.2.5. Calibrate level position
The Position view and the Weighing view are depending on a correctly calibrated implement, with regards to its calibrated level
position.
To use the implement position monitoring function in the Position view and Weighing view, it is necessary to calibrate the level
position of the implement.
The level position for an implement is calibrated in the Implement view, by selecting the desired implement and then Calibrate
level position.
Implements
fork / cal.a
balegrip / cal.b
bucket / gravel
New implement
1. Select which implement to
configure.
2. Select Delete and press confirm.
Fig.12 Delete implement
bucket
Select
Calibrate level position
Weighing calibrations
Edit name
Delete
2. Select Calibrate level position
and confirm by pressing the
check mark.
Fig.13 Calibrate level position
14
bucket
Select
Calibrate level position
Weighing calibrations
Edit name
Delete
bucket
Set implement to level position
and confirm
3. Control the implement to its
horizontal level. Confirm by
pressing the check mark.