Safety Warnings - Makita DLS600 Betriebsanleitung

Do not dispose of electric equipment or battery
Li-ion
pack together with household waste material!
In observance of the European Directives,
on Waste Electric and Electronic Equipment
and Batteries and Accumulators and Waste
Batteries and Accumulators and their
implementation in accordance with national
laws, electric equipment and batteries and
battery pack(s) that have reached the end
of their life must be collected separately
and returned to an environmentally
compatible recycling facility.
Intended use
The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.
Do not use the saw to cut other than wood, aluminum or
similar materials.
Noise
The typical A-weighted noise level determined according
to EN62841:
Sound pressure level (L
Sound power level (L
WA
Uncertainty (K) : 3 dB(A)
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN62841: Vibration
2
emission (a ) : 2.5 m/s
h
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value may
also be used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an
estimation of exposure in the actual conditions of use
(taking account of all parts of the operating cycle such
as the times when the tool is switched off and when it
is running idle in addition to the trigger time).
) : 90 dB(A)
pA
) : 97 dB (A)
WARNING:
or less
2
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.

SAFETY WARNINGS

General power tool safety warnings
WARNING:
instructions, illustrations and specifications
provided with this power tool. Failure to follow all
instructions listed below may
electric
serious
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Safety instructions for mitre saws
1. Mitre saws are intended to cut wood or
woodlike products, they cannot be used with
abrasive cut-off wheels for cutting ferrous
material such as bars, rods, studs, etc.
Abrasive dust causes moving parts such as the
lower guard to jam.
abrasive
the
other plastic parts.
2. Use clamps to support the workpiece
whenever possible. If supporting the
workpiece by hand, you must always keep
your hand at least 100 mm from either side of
the saw blade. Do not use this saw to cut
pieces that are too small to be securely
clamped or held by hand. If your hand is placed
too close to the saw blade, there is an increased
risk
blade
3. The workpiece must be stationary and
clamped or held against both the fence and the
table. Do not feed the workpiece into the blade
or cut "freehand" in any way. Unrestrained or
moving workpieces could be thrown at high
speeds,
4. Never cross your hand over the intended line
of cutting either in front or behind the saw
blade.
18 ENGLISH
Read all safety warnings,
result
shock, fire
injury.
Sparks
cutting will
lower guard, the kerf insert and
of injury
contact.
causing injury.
in
and/or
from
burn
from