General Power Tool Safety Warnings; Additional Safety Rules For Tool - Makita LS0815F Bedienungsanleitung

Noise
The typical A-weighted
according to EN61029:
Sound pressure level (L
Sound power level (L
WA
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total value
determined according to EN61029:
Vibration emission (a
h
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Slide Compound Miter Saw
Model No./ Type:
LS0815F, LS0815FL
Conforms to the following European Directives:
2006/42/EC, 2006/95/EC, 2011/108/EC,
2011/65/EU
They are manufactured in accordance with the following
standard or standardized documents:
EN61029, EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
All manuals and user guides at all-guides.com
ENG905-1
noise level determined
) : 87 dB (A)
pA
) : 110 dB (A)
ENG900-1
(tri-axial vector sum)
2
) : 2.5 m/s or less
2
ENG901-1
ENH103-1
20.12.2013
000331
Yasushi Fukaya
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for
future reference.
ADDITIONAL SAFETY RULES
FOR TOOL
1. Wear eye protection.
2. Keep hands out of path of saw blade. Avoid
contact with any coasting blade. It can still
cause severe injury.
3. Do not operate saw without guards in place.
Check blade guard for proper closing before
each use. Do not operate saw if blade guard
does not move freely and close instantly.
Never clamp or tie the blade guard into the
open position.
4. Do not perform any operation freehand. The
workpiece must be secured firmly against the turn base
and guide fence with the vise during all operations.
Never use your hand to secure the workpiece.
5. Never reach around saw blade.
6. Turn off tool and wait for saw blade to stop
before moving
settings.
7. Unplug tool before
servicing.
8. Always secure all moving portions before
carrying the tool.
9. Stopper pin which locks the cutter head down
is for carrying and storage purposes only and
not for any cutting operations.
10. Do not use the tool in the presence of flammable
liquids or gases. The electrical operation of the tool
could create an explosion and fire when exposed to
flammable liquids or gases.
11. Check the blade carefully for cracks or
damage before operation.
Replace cracked
immediately.
9
Director
GEA010-1
ENB034-7
workpiece or changing
changing blade
or damaged blade
or