Makita DLS600 Betriebsanleitung Seite 26

so that the
does not contact
boards. Before use,
kerf boards as follows:
1. Make sure to remove the battery cartridge. Then,
loosen all the screws (2 each on left and right)
securing the kerf boards.
►
Fig.12: 1. Kerf board 2. Screw
2. Re-tighten them only to the extent that the kerf
boards can still be easily moved by hand.
3. Lower the handle fully and push in the stopper pin
to lock the handle in the lowered position.
4. Adjust the
so that
boards just
the blade teeth. ►
►
Fig.14: 1. Saw blade 2. Blade teeth 3. Kerf
board
4. Left bevel cut 5. Straight cut
5. Tighten the
not tighten
6. After adjusting the
release the
and raise the handle. Then tighten all the
screws securely.
NOTICE:
After setting the bevel angle ensure that
the kerf boards are adjusted properly. Correct
adjustment of
boards helps
proper support of the workpiece and
minimizing workpiece tear out.
Maintaining maximum cutting
capacity
This tool is
to provide the
capacity for a 165 mm saw blade. When installing a
new blade, always check the lower limit position
of the blade,
necessary, adjust it
1. Remove the battery cartridge. Lower the
handle completely.
2. Use the
to turn
limit adjusting bolt until the saw blade
comes slightly below the cross section of the guide
fence and the top surface of the turn base. ► Fig.15:
1. Adjusting bolt
►
Fig.16: 1. Guide fence
3. Rotate the blade by hand while holding the
handle all the way down to be sure that the blade does
not contact any part
saw blade
the kerf
adjust the
kerf boards
the kerf
contact the sides of
Fig.13
screws (do
firmly).
kerf boards,
stopper pin
the kerf
to provide
factory adjusted
maximum cutting
and if
as follows:
hex wrench
the lower
of the
26 ENGLISH
lower base.
if necessary.
WARNING:
After installing a new blade and
with the battery cartridge removed, always be
sure that the blade does not contact any part of
the lower base when the handle is lowered
completely. If a blade makes contact with the base it
may cause kickback
serious
►
Fig.17
Sub-fence
Country specific
This tool is equipped with the sub-fence and small sub-
fences.
Sub-fence
WARNING:
Always remove sub-fence when
performing bevel cuts. Failure to do so may cause
serious injury.
►
Fig.18: 1. Sub-fence
When performing cuts except for bevel cuts, use the
sub-fence to support the workpiece.
Small sub-fence
CAUTION:
When performing right bevel cuts,
fold the small sub-fences. Otherwise, they may
contact the blade or a part of the tool, and may result
in serious
operator.
►
Fig.19: 1. Small sub-fence 2. Scale
When performing vertical
left bevel cut,
upward to support the workpiece. The guide fence has
a scale of 10 mm interval.
Adjusting the miter angle
►
Fig.20: 1. Fixing screw 2. Turn base 3.
Miter scale
4. Pointer
1. Loosen the
counterclockwise.
2. Adjust the
the turn
the pointer
as a guide. 3. Tighten
screw clockwise firmly.
CAUTION:
After changing the miter angle,
always secure the turn base by tightening the
fixing screw firmly.
Re-adjust slightly,
and result in
personal injury.
injury to the
cut or
flip them
fixing screw
angle of
base. Use
and the miter scale
the fixing