Functional Description - Makita DLS600 Betriebsanleitung

FUNCTIONAL
DESCRIPTION
WARNING:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking the functions on the
tool. Failure to switch off and remove the battery
cartridge may
personal
accidental start-up.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery
cartridge firmly when installing or removing
battery cartridge. Failure to hold the tool and the
battery cartridge
them
your
damage to the tool and battery cartridge and a
personal
►
Fig.5: 1. Red indicator 2. Button 3. Battery
cartridge
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may
out
causing
someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
Tool / battery protection system
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will
automatically stop during operation if the tool or battery
is placed under one of the following conditions:
result in
injury from
firmly may
to slip
hands and result in
injury.
accidentally
of the
injury to
Overload protection
When the tool is operated in a manner that causes it to
draw an abnormally high current, the tool automatically
stops without any indication. In this situation, turn the
tool off and stop the application that caused the tool to
become overloaded. Then turn the tool on to restart.
Overheat protection
serious
When the tool is overheated, the tool stops
automatically, and the battery indicator blinks about 60
seconds. In this situation, let the tool cool down before
turning the tool on again.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically. If the product does not operate even
cause
when the switches are operated, remove the batteries
off
from the tool and charge the batteries.
Canceling lock by protection system
If the protection system is activated repeatedly, the tool
is locked and the battery indicator blinks.
In this case, turn off the switch and remove the cause
which is activating the protection system, and then turn
on the switch again. If the tool does not work after
turning on the switch again, remove the battery
cartridge and charge it.
fall
Indicating the remaining battery
tool,
capacity
you or
►
When you pull the switch trigger, the battery indicator
indicates the remaining battery capacity.
23 ENGLISH
On
Blinking
Fig.6: 1. Battery indicator
Blinking