Measuring The Density Of A Floating Solid Using Water - OHAUS PJX Serie Bedienungsanleitung

PJX Series Balance
6. After completion of the test, press the Function / Mode
button to test a new sample.

4.4.2 Measuring the Density of a Floating Solid Using Water

Long press the Function / Mode button until the Density
appears on the screen.
In determining density with the balance, the balance setup and
density determination procedures are basically the same for a
floating solid and a non-floating solid except for the necessary
holder (as shown in the figure) to be used for density determination.
After completion of the test, press the Function / Mode button to
test a new sample.
Note: Push the sample down into the liquid until it is fully
submerged.
Holder for non- Holder for floating
floating solids
EN-17
solids