Measuring The Density Of A Buoyant Material Using Water; Measuring The Density Of A Solid Using An Auxiliary Liquid - OHAUS Adventurer AX5202 Bedienungsanleitung

EN-18
Once the necessary weights have been determined, the density of the sample is displayed in g/cm
(along with the weight in air, weight in water) on the Application screen.
Press Start to reset all the weight values and restart the process.
4.5.2

Measuring the Density of a Buoyant Material Using Water

Press the Item Settings button to open Settings screen.
Confirm the following Setups are selected:
 Density Type: Solid
 Liquid Type: Water
 Porous Material: Off
Press Back to return to the Density Determination home
screen.
Follow the same procedure as Solid Material above, except
in Density Determination step 2, push the sample down
into the liquid until it is fully submerged.
4.5.3

Measuring the Density of a Solid Using an Auxiliary Liquid

To enable this feature, enter the Density Determination Setup menu and select the following:
Density Type: Solid; Liquid Type: Other; Porous Material: Off.
Confirm the default values displayed (Liquid Density, etc) are
correct.
To adjust the Liquid Density value, touch the Auxiliary liquid
button and select Other.
A numeric input window appears.
Key in the density in g/cm
The display returns to the previous screen.
To return to the Density Determination home screen,
touch Back.
Begin the Density determination process as per above.
Find Quality Products Online at:
Step 2 of 2 –
Weigh the
Sample
Submerged in
the Liquid.
Follow the
screen
instructions,
then press
Accept
to store the
sample weight
(submerged
in liquid).
3
, then press Save.
GlobalTestSupply
www.
ADVENTURER BALANCES
3
.com
sales@GlobalTestSupply.com