Measuring The Density Of A Floating Solid Using Water; Measuring The Density Of A Solid Using An Auxiliary Liquid Other Than Water - OHAUS Pioneer PX Series Bedienungsanleitung

EN-18
3. Press the Function / Mode button to get the density of the
sample. After completion of the test, press the Function /
Mode button to test a new sample.

4.5.2 Measuring the Density of a floating Solid Using Water

1.
Press and hold the Function / Mode button until Density
appears. Press Yes to enter the Density Determination.
2.
In determining density with the balance, the balance
setup and density determination procedures are basically
the same for a floating solid and a non-floating solid
except for the necessary holder (as shown in the figure)
to be used for density determination.
3.
After completion of the test, press the Function / Mode
button to test a new sample.
Note: Lower the sample down into the liquid until it is fully
submerged.

4.5.3 Measuring the Density of a Solid Using an Auxiliary Liquid other than Water

1. Press and hold the Function / Mode button until Density
appears. Press Yes to enter the Density Determination.
Holder for non-floating
solids
PX Series Balance
Holder for floating
solids