Assembly Instruction - SPORTSTECH SX100 Benutzerhandbuch

ASSEMBLY INSTRUCTION

Preparation
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available. Under the QR code / link on the
previous page you will find a numbered exploded drawing with all the individual parts that make up the speed
bike.
Firmly tighten all component parts
and pre-assembled parts!
Assembly instruction:
1 1.2
2.2
2
1)
Connect the front tube with the frame, and
install the plain washer Ø10, washer 10
to the bolts and put on the cover-shaped
screws. And use open spanner to fasten
them. Installation of back tube is the same.
Note: Please adjust the black feet strap to make it
balance if it is not stable.
2)
The feet straps are marked with L and R.
Please drop 2 red screw locking liquid in
R strap and fasten it with right threaded
hole by using our spanner. And drop 2 red
screw locking liquid in L strap and fasten it
with left threaded hole.
Note: L and R are marked in crank as well. Please
install them accordingly otherwise it will damage
the products. And please fasten the feet strap, or
it will fall down after long usage.
22
3)
Loose the brake and adjust the cushion to
appropriate height. And fasten the brake and
seats.
3
a)
You can adjust the cushion seat back and for
ward by loosing the plum-head bolts to a
comfortable situation. Then just lock it please.
4)
Take out the armrest fixed seats, put it through
the square-shaped tube then fasten them by using
locking screws and you can also adjust the height.
4
3.a
23
EN