Assembly Instructions - SPORTSTECH SX 500 Benutzerhandbuch

Preparation
• Before assembling make sure that you will have enough space around the item.
• Use the present tooling for assembling.
• Before assembling please check whether all needed parts are available. (on the previous page of
this manual you will find an explosion drawing with all single parts (marked with numbers) which
this item consists of.
Assembly Instruction:
16
6
5
4
3
13
12
10
20
19
26
16

3. ASSEMBLY INSTRUCTIONS

15
7
29
Attach the front ftabilizer (pt.15) to the
main frame (pt.16) using two sets of
Ø10 arc washers (pt.5), M10 domed
nut (pt.6) and M8*90 carriage bolt (3).
Attach the rear stabilizer (pt.4) to the
main frame (pt.16) using two sets of
Ø10 arc washers (pt.5), M10 domed
nut (pt.6) and M8*90 carriage bolt (3).
Slide the vertical seat post (pt.10) into
the seat post housing on the main
frame (pt.16). Then slide the seat
post (pt.12) into the vertical seat post
(pt.10), then secure using a flat washer
1 (20) and L-shape knob (19).You will
have to slacken the knurled section of
the L-shape knob (pt.19) and pull the
knob back and then select the desired
height. Release the knob and retighten
the knurled portion.
Now fix the seat (pt.13) to the seat post
(pt.12) as shown, and tighten the bolts
around the screws under the seat.
EN