Assembly Instructions - SPORTSTECH SX400 Benutzerhandbuch

Preparation
• Before assembling make sure that you will have enough space around the item.
• Use the present tooling for assembling.
• Before assembling please check whether all needed parts are available (at the above of this inst-
ruction sheet you will find an explosion drawing with all single parts (marked with numbers) which
this item consists of.
Assembly Instruction:

ASSEMBLY INSTRUCTIONS

33
Attach the Front Stabilizer (pt.15) to the Main Frame
(pt.16) using two sets of Ø10 Arc Washers (pt.5), M10
Domed Nut (pt.6) and M8*90 Carriage bolt (3).
Attach the Rear Stabilizer (pt.4) to the Main Frame
(pt.16) using two sets of Ø10 Arc Washers (pt.5), M10
Domed Nut (pt.6) and M8*90 Carriage bolt (3).
Slide the Vertical Seat Post (pt.10) into the seat post
housing on the main frame (pt.16). Then slide the Seat
Post (pt.12) into the Vertical Seat Post (pt.10),then
Secure using a flat washer 1 (20) and L Shape knob
(19).You will have to slacken the knurled section of
the L Shape Knob (pt.19) and pull the knob back and
then select the desired height. Release the knob and
retighten the knurled portion.
Now fix the Seat (pt.13) to the Seat Post (pt.12) as
shown, and tighten the bolts around the screws under
the seat.