Towing The Vehicle - Kärcher MIC 70 Bedienungsanleitung

1. Park the vehicle.
2. Secure the vehicle with lashing straps on both sides of
the illustrated fastening points.

10.2 Towing the vehicle

ATTENTION
Risk of damage due to incorrect towing
Towing a hydrostatically driven vehicle is possible only to
a limited extent; mostly limited to a few metres. Therefore,
only tow the vehicle out of the hazard zone of the moving
traffic, and make sure you have transport facilities.
Only tow the vehicle at walking speed.
Approach slowly and not jerkily.
Only fasten the vehicle for towing purposes to the towing
eye (front) or trailer coupling (rear).
Preferentially, use a suitable tow bar.
1. In order to tow the vehicle, the hydraulic brake cylinders
must first be released and the two bypass valves
opened.
10.2.1Fitting the towing eye
Note
The towing eye with retaining pin and locking pin can be
found in the driver cabin.
In vehicles without EC type-approval, it is not in the scope
of delivery, but can be ordered as accessories (order num-
ber 2.852-220.0).
Towing eye
1
Retaining pin
2
Locking pin
3
Locking pin for bolt
4
Bolt
5
1. Take the towing eye out of the driver cabin.
70
Retaining pin with locking pin
1
Towing eye
2
Vehicle chassis
3
Bolt
4
Locking pin
5
2. Attach the towing eye at the front of the vehicle chassis
on the right-hand side.
3. Insert the retaining pin into the towing eye and secure
with the locking pin.
10.2.2Releasing the hydraulic brake cylinder
The nuts for releasing the brake cylinders are located to
the left and right of the articulated joint.
Hydraulic brake cylinder
1
1. Release the nut on the hydraulic brake cylinder to the
left and right.
10.2.3Opening the bypass valves
The bypass valves are located on the bottom side, in the
front area of the rear end.
English