Position Of Warning Symbols; Safety Devices - Kärcher MIC 70 Bedienungsanleitung

4.10 Position of warning symbols

Note
Immediately replace illegible or lost warning symbols.

4.11 Safety devices

Safety devices protect the user and may not taken out of
operation or functionally circumvented.
Adhere to the safety instructions in the chapters!
4.11.1Main switch
Main switch
1
Battery disconnected
2
Battery connected
3
The main switch interrupts the electrical supply line to the
starter motor.
If the main switch is pressed when the engine is running
(battery disconnected), the engine will stop.
Always disconnect the battery when the vehicle is parked.
4.11.2MIC 70 start inhibit
Requirements for starting the engine:
● Put the main switch into the "battery connected" posi-
tion.
● Wait until the booting up of the display has been com-
pleted.
4.11.3MIC 70 seat contact switch
When the driver's seat is vacant:
● The vehicle will go automatically to neutral position.
Note
Then put the travel direction switch on the joystick to cen-
tral position <Neutral/Stop>.
● Is the working hydraulics PTO automatically switched
off, or will it get switched off?
4.11.4Parking brake automatic
The warning light in the multifunction display
lights up when the parking brake is active.
1 If the engine has stopped or if the travel direction switch
is at NEUTRAL when the engine is running, then the
parking brake is activated automatically.
2 If the travel direction switch is pressed when the engine
is running (FORWARDS or REVERSE), then the park-
ing brake will be released.
4.11.5Driver cabin
The operator is protected from lightning strikes when sit-
ting in the driver cabin.
The driver cabin has a roll-over protection structure
(ROPS), which prevents rolling over after tipping over.
The driver cabin does not have a structure providing pro-
tection from falling objects (FOPS).
The driver cabin does not have a structure providing pro-
tection from falling objects (OPS).
Always use the safety belt.
English 49