Cleaning - Kärcher MIC 70 Bedienungsanleitung

12.7.17Changing the dust filter on the outer cabin
Cover
1
Dust filter
2
Note
Fine filter filter grade F8 (available as option)
1. Unscrew the 6 screws for the cover.
2. Remove the cover.
3. Take out the dust filter.
4. Blow out the slightly contaminated dust filter using com-
pressed air (reduced pressure). Renew severely con-
taminated dust filter.
5. Insert the new or cleaned filter.
12.7.18Changing the dust filter on the inner cabin
Clamping lever
1
Cover
2
Dust filter
3
Note
Fine filter filter grade F8 (available as option)
1. Release the clamping lever.
2. Remove the cover in an upward direction.
3. Take out the dust filter.
4. Replace the dust filter.
Check that the seal and dust filter are correctly fitted
during installation.
5. Attach the cover.
6. Actuate the clamping lever.
78
12.7.19Changing the dust filter behind the driver's
seat
Driver's seat
1
Dust filter
2
Air recirculation lever
3
1. Push the driver's seat completely forwards.
2. Take out the dust filter.
3. Replace the dust filter.
4. Push the driver's seat backwards.

12.8 Cleaning

CAUTION
Risk of injury and damage
Always secure the tipping mechanism.
1. Park the vehicle on a level surface.
2. Switch off the ignition and remove the ignition key.
3. Apply the parking brake.
4. Switch off the main switch.
12.8.1Cleaning the vehicle
Clean the vehicle daily after finishing work.
CAUTION
Risk of damage through incorrect cleaning
The articulated joint, tyres, radiator fins, hydraulic hoses
and valves, seals, electrical and electronic components
must not be cleaned using a high-pressure cleaner.
Observe the respective safety regulations when cleaning
the vehicle with a high-pressure cleaner.
Do not use aggressive cleaning agents.
Wash the vehicle only when the engine is switched off to
protect the air filter.
1. To avoid a risk of fire, check the vehicle for escaping oil
and fuel. Have leaks repaired by Customer Service.
2. Clean all plant residues and oil from the engine, muffler,
battery and fuel tank to avoid a risk of fire.
3. If necessary, clean the engine with a brush, compressed
air or with low water pressure if necessary.
4. Clean the wheel mudguards.
12.8.2Cleaning the radiator
ATTENTION
Overheating due to contamination
Always keep the radiator grille, suction mesh and blower
clear of damage, plant residues and other types of contam-
ination.
1. Remove the radiator protective grille.
see chapter 12.7.5 Radiator protective grille
2. Remove coarse dirt deposits from the engine radiator,
hydraulic oil cooler and air-conditioner radiator (option).
English