Connecting The Oven; Inserting The Oven - hanseatic 65M90E3-E11B200 Gebrauchsanleitung

Page EN-28 Installation

Connecting the oven

Depending on the installation recess, the
oven must be connected before or after in-
stallation.
– For the electrical connection of the oven, a
professional must install an earthed power
socket with a separate fuse with sufficient
protection (230 V~/50 Hz/16 A).
– The socket must be installed in way that
does not affect the depth of the installation
recess when the oven is plugged in.
– Do not use multi-plugs or extension cables.
1. Switch off the socket for the oven before
installation. To do this, unscrew and/or
switch off the fuse for the socket.
2. Insert the mains plug into the socket.

Inserting the oven

WARNING
Risk of electric shock!
Incorrect installation/dismantling can
cause electric shock.
■ Before
installing/dismantling
appliance, check that the socket to
which the appliance is connected is
switched off.
NOTICE
Risk of damage!
Improper handling of the appliance
can result in damage.
■ Do not set the oven down on the edge
or corner of the oven door! The glass
panels can be damaged.
1. Push the oven into the recess until the
front fascia is flush with the installation
unit.
The mains connection must not be kinked,
pinched or otherwise damaged.
2. Ensure an even gap between the oven
and the unit walls on both sides. Do not
seal the gap above the oven fascia.
(5) (6)
3. If the oven is correctly set up, open the
open the oven door and screw it to the
built-in cupboard using the included as-
the sembly material. Use the screws (5) and
the spacers (6).
4. Switch the socket fuse back on.
The oven must be pre-cleaned to
remove all grease and oil residues
from the manufacturing process, as well
as tough dust deposits left over from stor-
age and transportation. This not only helps
protect your health but also ensures deli-
cious cakes and roasts (see 'Basic cleaning'
page EN-21).