Changing The Door Hinges - hanseatic HWC31GCIA Gebrauchsanleitung

NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~/50 Hz). The temperature
indicator (10) will light up. The appliance
is switched on.
You will find all important information
about operation from page EN-11.

Changing the door hinges

CAUTION
Risk of injury!
The glass door is very heavy.
Ask another person, if needed, to help
■
you with attaching or removing the
glass door.
NOTICE
Risk of damage!
Improper handling of the appliance
may result in damage.
Do not tilt the appliance more than
■
45°.
Do not lay it on its side.
■
Start-up
Depending on the space conditions, you can
change the direction of the door hinges on
your appliance. This work, however, requires
you to have a certain degree of craftsmanship
skills. Please read the following steps com-
pletely before changing the hinges.
You will need the following tools to change
the door hinges:
– medium size cross-tip screwdriver
– medium size flat-headed screwdriver
1. Ensure that the appliance is not connect-
ed to the power supply.
(18)
2. Unscrew the two screws (18) from the
lower hinge.
3. Open the glass door and remove it.
Page EN-23