Risk Of Damage - hanseatic HWC20FCBH Gebrauchsanleitung

Page EN-8 Safety
Clean regularly surfaces that can
■
come in contact with food and acces-
sible drainage systems.
If the refrigerating appliance is left
■
empty for long periods, switch off,
defrost, clean, dry, and leave the door
open to prevent mould developing
within the appliance.
Incorrect handling, insuffi cient cool-
ing or overlapping items can spoil the
stored food. This could lead to a risk of
food poisoning when consumed!
Abide by the storage times recom-
■
mended by food manufacturers.
Health hazard!
The appliance may not operate proper-
ly if the ambient temperature exceeds
or falls below the specifi ed temperature
range for a prolonged period. This can
then lead to an increase in temperature
inside the appliance.
Always ensure the prescribed ambi-
■
ent temperature is maintained (see
"Intended use" on page EN-4).

Risk of damage

NOTICE
Risk of damage to property!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
If possible, only transport the appli-
■
ance in a vertical position.
Allow the refrigerator to stand up-
■
right for two hours before start-up.
The lubricant will fl ow back into the
compressor during this time.
Improper handling of the appliance
can lead to damage to property.
Do not pull or lift the appliance by its
■
doors or door handles.
Place the appliance only on a lev-
■
el and fi rm surface that can support
the weight of the appliance when it
is fi lled.
Do not use sharp or pointed objects
■
to unpack it.
When unpacking the appliance, nev-
■
er damage the insulation material on
the back of the appliance.
Do not use mechanical devices or oth-
■
er means to accelerate the defrosting
procmess, other than those recom-
mended by the manufacturer.
The interior light must only be used
■
to illuminate the interior of the appli-
ance. It is not suitable for lighting a
room.
When cleaning, please note:
■
Never use harsh, granular, soda,
–
acid, solvent-based or abrasive
cleaners. These attack the plastic
surfaces. All-purpose cleaners with
a neutral pH are recommended.
Door seals and plastic parts are
–
sensitive to oil and grease. Remove
contaminants as quickly as possi-
ble.
Use only soft cloths for cleaning.
–
Wait 5 minutes after switching off.
■
Only then switch the appliance on
again.