Risk Of Damage - hanseatic JC-201S Gebrauchsanleitung

Page GB-8 Appliance parts / control element
Risk of injury!
Improper handling of the appliance
may result in injury.
The appliance is heavy and bulky.
■
Seek the help of another person when
moving the appliance and changing
the door hinges.
Check that entry route and instal-
■
lation location are free of obstacles
(e.g. closed doors or objects lying on
the fl oor).
Wear protective gloves when moving/
■
installing the appliance and chang-
ing the door hinges.
Bases, doors, etc. must not be used as
■
steps or for support purposes.
Do not place any heavy objects on
■
the appliance.
Take care to prevent the risk of trip-
■
ping when laying the mains cord.
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
Always abide by the prescribed am-
■
bient temperature (see product data
sheet at the end of this user manual).
NOTICE

Risk of damage

If the appliance has been transported
horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Do not tilt the appliance more than
■
45° or lay it on its side.
Allow the cooling unit to stand up-
■
right for 2 hours before start-up. The
lubricant will fl ow back into the com-
pressor during this time.
Improper handling of the appliance
can lead to property damage.
Do not use the door to pull or lift the
■
appliance.
The appliance must only be placed
■
on a level and fi rm surface. The sur-
face must be strong enough to sup-
port the appliance's weight when ful-
ly laden.
Do not operate the appliance near
■
sinks, taps or containers fi lled with
liquids such as vases, aquariums, etc.
Make sure that the device does not
get wet.
The maximum load of 14 bottles per
■
bottle shelf must not be exceeded.
Do not use sharp or pointed objects
■
to unpack it.
Do not use any electrical parts inside
■
the appliance that do not conform to
the manufacturer's recommended
design.
Do not use any mechanical devices or
■
means other than those recommend-
ed by the manufacturer.
When cleaning, please note:
■
Never use harsh, granular, soda,
–
acid, solvent-based or abrasive
cleaners. These attack the plastic
surfaces. All-purpose cleaners with
a neutral pH are recommended.
Door seals and plastic parts are
–
sensitive to oil and grease. Remove
contaminants as quickly as possi-
ble.
Do not clean the appliance parts in
–
the dishwasher.
Use only soft cloths for cleaning.
–
Wait 5 minutes after switching off.
■
Only then switch the appliance on
again.
Only use original accessories.
■