Network - Avtech avh304 Bedienungsanleitung

4) VLOSS BUZZER
Select to enable or disable the sound when video loss happened (ON / OFF).
5) MOTION BUZZER
Select to enable or disable the sound when any motion alarm is triggered (ON / OFF).
6) ALARM BUZZER
Select to enable or disable the sound when any internal alarm is triggered (ON / OFF).
7) HDD BUZZER
Select to enable or disable the sound (ON / OFF) when the HDD remaining capacity reaches to the value set
in "HDD NEARLY FULL (GB)".
8) ALARM DURATION (SEC)
Select the duration time for alarm buzzer in second (5 / 10 / 20 / 40).
9) HDD NEARLY FULL (GB)
If HDD BUZZER is enabled, select the duration time for buzzer notifications when the hard disk available
capacity is 5/10/15/20 GB left.
10) HDD OVERHEAT ALERT (°C)
Select the temperature alert for your hard disk to be aware of the possible overheat of your hard disk.

5.4.5 NETWORK

There are two RJ45 ports on the rear panel: WAN and LAN.
 WAN is used to connect this recorder to Internet for remote access from anywhere as long as Internet access is
available.
 LAN is used to connect to IP cameras locally.
 DDNS is used when the Internet access is available.
Note: For more details about these three functions and network configurations, please get the setup
manual from the supplied CD or from
www.surveillance-download.com/user/network_setup/network_setup_recorder.pdf.
CONNECTION
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
NOTIFY
EXIT
Downloaded from www.Manualslib.com
ADVANCED CONFIG
WAN LAN E-MAIL DDNS NETWORK MONITOR
NETWORK TYPE
IP
GATEWAY
NETMASK
PRIMARY DNS
SECONDARY DNS
PORT
manuals search engine

DHCP
192.168.1.112
192.168.1.254
255.255.255.0
168.95.1.1
139.175.55.244
88
28
MAIN MENU