Routine Cleaning - Tennant F3 Bedienungsanleitung Und Ersatzteilliste

Machine operation
S Press the brush motor switch (2) (to the right or left).
The motor starts.
S If you raise the bar (7) slightly, the machine moves to
the right (D).
If you lower the bar, the machine moves to the left (D).
S
S If you keep the bar in its central position, the machine
works on the spot.
After use
S Squeeze the shaft adjustment handle (5) and shift the
bar (7) into its vertical position.
S Then tip the machine onto its wheels (9) and press
the brush motor switch (2) briefly. The accessory (11)
disengages.
Remove the plug from the power socket and wind the
S
electric cable around the handle bar (1) and cable
hook (8).
Thorough cleaning the easy way
For thorough cleaning, equip your machine with the following
accessories:
S Solution tank (13)
S Scrubbing brush (11) or drive plate with pad.
S Fasten the tank to the mounting (14).
S Slide the outlet hose (12) onto the water connector
(16).
Fill the tank (13). Then fit the brush or drive plate with
S
pad.
S Control the flow of liquid with the tank lever (15) by
pulling the lever (15) upwards.
S Vacuum the dirty wash solution a section at a time
with a water extractor.
Shampooing thoroughly and efficiently
For shampooing, equip your machine with the following
accessories:
Solution tank; 0.3 Perlon shampooing brush or pad for
S
textile floorcoverings.
S The working procedure is in principle the same as for
thorough cleaning.
S Start the machine with the shampooing brush dry.
S Meter a small amount of liquid until the bristles are
saturated with foam.
S Run the machine with the rotating brush from right to
left or viceversa. ⇒ Immediately after this, run the
machine in the same way
in the reverse direction, but with an overlap of about a
quarter of the strip already treated (E.)
Only then run the machine in a spiral pattern over the
S
shampooed strips. ⇒ In doing so, work both strips at
the same time (F.)
S During shampooing it is highly advisable to
immediately remove the dirt- -laden foam a section at a
time with a water extractor.
F3/F8/F12 9002026 (12- -09)
Home
Assembly instructions for spray unit

Routine cleaning

For routine cleaning, equip your machine with the following
accessories:
Polishing with F12/F8 high speed
For polishing, equip your machine with the following
accessories:
Find... Go To..
English
S Fit the holder for the spray can to the bar (7) with the
holder pointing upwards and, when viewed from the
operating side, to the left (G).
S Hook the spray can's tongue onto the holder, pivoting
the holder
back until the ball catch engages.
S Then slide the spring clip over the shaft adjustment
unit (7).
S Attach the box on the right or left as desired (H).
Point the universal- -jointed hose in the desired
S
direction.
S Spray unit, drive plate for pads, pad for F8/F3 low
speed or Spray unit, drive plate for pads, pad for
F12/F8 high speed
S Fill the spray can with the desired product.
S Fit the drive plate with the desired pad.
Start the machine.
S
S When you pull the Spray unit lever a few times the
cleaning agent is sprayed onto the floor. Now start
cleaning immediately until a shine is produced.
S We advise cleaning the surface in relatively small
areas at a time. The machine is ideal for cleaning with
polymer dispersions. The coating's resistance to foot
traffic and general wear and tear is preserved.
Streaks and marks are easier to remove.
S Drive plate for pads, white pad
S Fit the drive plate with the pad.
S Then start the machine.
EN
5