Technical Specifications - Tennant F3 Bedienungsanleitung Und Ersatzteilliste

Trouble Shooting
Problem
Machine does not operate
Machine operates with a wobbleor jerky
motion.
Machine circuit breaker trips continuously.

Technical specifications

A.C. motor
Rated power
Max.amp draw
Brush (rpm)
Brush (mm)
Working height (mm)
Working weight
Protection class
Belt- -driven
Sound pressure level LPA
Weighted acceleration value
EN
Model: F3, F8, F12
TENNANT N.V.
Industrielaan 6 5405 AB
P.O. Box 6 5400 AA
Uden -- The Netherlands
Uden, 25--04--06
Richard van den Hoogen -- Technical Support Engineer
F3/F8/F12 9002026 (12- -09)
Home
Cause
Faulty power cord.
Tripped circuit breaker
Faulty machine wiring.
Faulty motor.
Capacitor burned out.
Soiled Pad.
Improper pad/brush for application.
Pad driver/brush not installed correctly.
Pad/brush unevenly worn.
Pad not properly centered on pad driver
Heavily soiled pad/brush
Improper pad/brush for application
Defective circuit breaker.
Worn carbon brushes in motor.
F3 low speed
230 V: 50 Hz
1000 W
5,5 A
165
430
250
31 kg
llPx4
x
59db (A)
1.05 m/sec2
DECLERATION OF CONFORMITY FOR MACHINERY
(Directive 89/392/EEC, Annex II, sub A)
Machine nr.: MF122004, MF122904, MF32004, MF32904, MF82004, MF82904
Herewith declares, on our own responsibility, that the machinery
-- is in conformity with the provisions of Directive 89/392/EEC, 73/23/EWG and 89/336/EWG
-- The following standards and normative documents have been applied:
EN 60335--1 (ed.3);am1;am2, 60334--2--67(ed2);am1, EN60355--1:94+A1:96+A12:96+A13:98+A14:
98+A15:00+A2:00+A16:01,EN60355--2--67:98+A1:00, EMC:CISPR 14--1:00+A1:01,CISPR 14--2:01,
ICE61000--3--2:00,IEC61000--3--3:94+A1:01,EN55014--1:00+A1:01,EN 55014--2:97+A1:01,
EN61000--3--2:00, EN 61000--3--3:95+A1:01
Find... Go To..
English
Solution
Contact Service Center.
Wait 10 min. till machine cooled down and
try again.
Contact Service Center
Contact Service Center
Contact Service Center
Replace Pad
Change to proper pad/brush
Remove and reinstall pad driver/brush
Replace pad/brush
Remove and reinstall pad driver
Clean or replace pad/brush
Change to proper pad/brush
Contact Service Center
Contact Service Center
F8 high speed F12 Duo speed
230 V: 50 Hz 230 V: 50 Hz
1100 W 1200/1500 W
5,5 A 5,2 / 8,1 A
400 170/340
430
250
31 kg
lPx4
x
59db (A)
1.05 m/sec2 1.05 m/sec2
EN
430
250
37 kg
lPx4
x
65db
7