Primary Filter En; Replacing The Primary Filter En; Cleaning Outer Surfaces En - Abicor Binzel xFUME FLEX Betriebsanleitung

xFUME FLEX
9.3 Primary filter
The primary filter cannot be cleaned; it must be completely replaced.
9.3.1 Replacing the primary filter
Figure
 Fig. 5 on page EN-15
Without
Without
Without
Without
Tab. 9 Replacing the primary filter
9.4 Cleaning outer surfaces
1 Clean outer surfaces with a suitable industrial vacuum cleaner (dust class H according to DIN EN 60335-2-69
Appendix AA) or a damp cloth.
2 Dispose of cleaning residues/cloths in accordance with local regulations.
BAL.0733.0 • 2020-12-04
9 Maintenance and cleaning
Action
1 Switch off the welding fume extraction system at
the On/Off switch (4).
2 Pull out the mains plug.
3 Unlock and open the service door using a square
wrench.
4 Remove the primary filter.
5 Dispose of the primary filter in accordance with local
regulations.
 12 Disposal on page EN-23
6 Insert the new primary filter in xFUME FLEX.
7 Close the service door and lock it using a square wrench.
EN - 19