Control Elements En; Decommissioning - Abicor Binzel xFUME FLEX Betriebsanleitung

xFUME FLEX
7.1 Control elements
8
7
6
1 Extraction arm
2 Handle
Fig. 5 Control elements
1 Adjust the extraction arm (1) to accommodate the work task.
2 Adjust the extraction hood (6) to accommodate the work task. The extraction hood must be located approx. 20 cm above
the welding point during operation.
3 Establish an electrical connection.
4 Switch on the LED light (7) on the extraction hood (6).
5 Adjust air volume to the work task.
6 Use the On/Off switch (4) to switch on the welding fume extraction system.

8 Decommissioning

 Fig. 5 Control elements on page EN-15
1 Use the On/Off switch (4) to switch off the welding fume extraction system.
2 Disconnect the welding fume extraction system from the power supply.
BAL.0733.0 • 2020-12-04
1
2
3
4
5
3 Service door 5
4 Device On/Off 6
4 castors 7 LED light
Extraction hood 8 Light switch
8 Decommissioning
EN - 15