Inspection/Service Intervals En; Pre-Filter En - Abicor Binzel xFUME FLEX Betriebsanleitung

xFUME FLEX
xFUME FLEX has two filter elements used to filter welding fumes. The pre-filter (1) removes coarse welding fume particles
from the welding fumes. Fine welding fume particles are removed by the primary filter (2) and collected there.
1 Pre-filter
Fig. 6 Filter elements
9.1 Inspection/service intervals
If the device is operated for more than 8 hours a day, the maintenance intervals should be changed as needed. Regular
maintenance keeps the device in good visual condition and good working order.
NOTICE
• The specified maintenance intervals are standard values and refer to single-shift operation.
• We recommend recording the inspections. The date of the inspection, the detected defects and the name of the
inspector must be recorded.
Daily
• Check the pre-filter; replace the
filter pad as needed
 9.2.1 on page EN-18
• Check the primary filter and
replace as needed.
 9.3.1 on page EN-19
Tab. 7 Inspection/service intervals
BAL.0733.0 • 2020-12-04
1
2
2 Primary filter
Weekly
• Check the extraction arm and replace
as needed.
 9.5 on page EN-20
9 Maintenance and cleaning
Monthly
• Clean outer surfaces.
 9.4 on page EN-19
EN - 17