Control Elements; After Long Periods Of Non-Use; Putting Out Of Operation; Putting Out Of Operation For A Longer Period (Storage) - Abicor Binzel FES-200 W3 Betriebsanleitung

FES-200 W3

7.1 Control elements

1
5
1 Manometer
2 Rocker switch
Fig. 9
Control elements

7.2 After long periods of non-use

 6 Putting into operation on page EN-18

8 Putting out of operation

 Fig. 9 Control elements on page EN-21
1 Switch off the fume extraction system by turning the rocker switch (2) (0 position).
2 Unplug the mains plug from the socket to disconnect the fume extraction system.
NOTICE
• If the voltage circuit breaker (4) triggers, press it back in again.

8.1 Putting out of operation for a longer period (storage)

1 Switch off the fume extraction system by turning the rocker switch (2) (0 position).
2 After having switched off the fume extraction system, wait (for approx. 1 minute) until the dust has settled
down in the fume extraction system.
3 Dedust the filter
 5.2 Filter dedusting (dedusting by rotation) on page EN-14
4 Empty the dust collecting drawer
 5.1 Emptying the dust collecting drawer on page EN-13
NOTICE
• The fume extraction system must not be cleaned by means of a water jet.
5 Clean the dust collecting drawer using a damp disposable cloth or an appropriate industrial vacuum
cleaner.
3 Connection of mains connecting cable with plug
4 Voltage circuit breaker
8 Putting out of operation
2
4 3
5 Start-stop pliers connector (4-pole)
EN - 21