Leica DMLS Bedienungsanleitung Seite 18

Power units*
Different power units are required for the
various types of lamp. Some of these vary from
country to country, see separate instructions.
Do not connect until the lamps have been
assembled → p. 18 – 21. Check the mains
voltage setting and correct if necessary or
use a series transformer, e. g. 100/230 V.
Spare lamps
Code nos. → p. 47.
Lamphousing 106* and 107, halogen lamp
Disconnect from power supply (external power
unit).
Unscrew screw (17.1) and remove cover.
Move the collector to the front (17.4; 16.2, does
not apply for LH 105/2 or 107).
Fig. 16 Lamphousing 106*, opened
1 12 V 100 W halogen lamp in holder, 2 Collector, 3 Diffusing
screen
1
2
3
18
Downloaded from www.Manualslib.com
Attention:
manuals search engine
Remove the defect lamp and put a new 12 V
100 W halogen lamp into the lamp holder without
tilting (16.1).
!
Attention:
Leave the protective covering on the lamp until it
is in its holder. Avoid making fingerprints on the
lamp or wipe off immediately.
Close the lamphousing (17.1).
Lamphousing 106 z*, halogen lamp
Disconnect from power supply (plug).
Loosen screws (18.4 and 18.9) with crosstip
screwdriver. Pull cut-out plug (18.11) slightly out
of socket (18.1) and flip up lid.
Unscrew screws (18.10) on the lamp holder and
pull out the lamp holder (Fig. 19). Remove defect
lamp and insert new 12 V 100 W halogen lamp.
!
Attention:
Leave the protective covering on the lamp until
it is in its holder! Avoid making fingerprints or
wipe off immediately.
Fig. 17 Lamphousing 106* and filter holder* for filters Ø 50 mm
1 Screw to open the lamphousing, 2, 3 x and y centration of
lamp*, 4 Collector focusing, 5, 7 Fixing screws, 6 Filter holder
(spacer) for filters Ø 50 mm
1
3 2 4 5 6 7